Molecular Biology / PCR / Variants of PCR / PCR Resource 2 -- from (Dr. Chen, Dept of Biochem. & Mol. Biology, Univ. College London)

Polymerase Chain Reaction

1) Add the following to a microfuge tube:
10 ul reaction buffer
1 ul 15 uM forward primer
1 ul 15 uM reverse primer
1 ul template DNA
5 ul 2 mM dNTP
8 ul 25 mM MgCl2 or MgSO4 (volume variable)
water (to make up to 100 ul)

2) Place tube in a thermocycler. Heat sample to 95C, then add 0.5 -1 ul of enzyme (Taq, Tli, Pfu etc.). Add a few drops of mineral oil.

3) Start the PCR cycles according the following schemes:

a) denaturation - 94C, 30-90 sec.
b) annealing - 55C (or -5C Tm), 0.5-2 min.
c) extension - 72C, 1 min. (time depends on length of PCR product and enzyme used)
repeat cycles 29 times

4) Add a final extension step of 5 min. to fill in any uncompleted polymerisation. Then cooled down to 4- 25C.

Note:
Most of the parameters can be varied to optimise the PCR (more at Tavi's PCR guide):

a)Mg⁺⁺ - one of the main variables - change the amount added if the PCR result is poor. Mg⁺⁺ affects the annealing of the oligo to the template DNA by stabilising the oligo-template interaction, it also stabilises the replication complex of polymerase with template-primer. It can therefore also increases non-specific annealing and produced undesirable PCR products (gives multiple bands in gel). EDTA which chelate Mg⁺⁺ can change the Mg⁺⁺ concentration.

b) Template DNA concentration - PCR is very powerful tool for DNA amplification therefore very little DNA is needed. But to reduce the likelihood of error by Taq DNA polymerase, a higher DNA concentration can be used, though too much template may increase the amount of contaminants and reduce efficiency.

c) Enzymes used - Taq DNA polymerase has a higher error rate (no proof-reading 3' to 5' exonuclease activity) than Tli or Pfu. Use Tli, Pfu or other polymerases with good proof-reading capability if high fidelity is needed. Taq, however, is less fussy than other polymerases and less likely to fail. It can be used in combination with other enzymes to increase its fidelity. Taq also tends to add extra A's at the 3'end (extra A's are useful forTA cloning but needs to be removed if blunt end ligation is to be done). More enzymes can also be added to improve efficiency (sinceTaq may be damaged in repeated cycling) but may increase non-specific PCR products. Vent polymerase may degrade primer and therefore not ideal for mutagenesis-by-PCR work.

d) dNTP - can use up to 1.5 mM dNTP. dNTP chelate Mg⁺⁺, therefore amount of Mg⁺⁺ used may need to be changed. However excessive dNTP can increase the error rate and possibly inhibits Taq. Lowering the dNTP (10-50 uM) may therefore also reduce error rate. Larger size PCR fragment need more dNTP.

e) primers - up to 3 uM of primers may be used, but high primer to template ratio can results in non-specific amplification and primer-dimer formation (note: store primers in small aliquots).

f) Primer design - check primer sequences to avoid primer-dimer formation. Add a GC-clamp at the 5' end if a restriction site is introduced there. One or two G or C at the 3' end is fine but try to avoid having too many (it can result in non-specific PCR products). Perfect complementarity of 18 bases or more is ideal. See Guide.

g) Thermal cycling - denaturation time can be increased if template GC content is high. Higher annealing temperature may be needed for primers with high GC content or longer primers (calculate Tm). Using a gradient (if your PCR machine permits it) is a useful way of determining the annealing temperature. Extension time should be extended for larger PCR products; but reduced it whenever possible to limit damage to enzyme. Extension time is also affected by the enzymes used e.g for Taq - assume 1000 base/min (also check suppliers' recommendations, actual rate is much higher). The number of cycle can be increased if the number of template DNA is very low, and decreased if high amount of template DNA is used (higher template DNA is preferable for PCR cloning - lower error rate in the PCR).

h) Additives -

1. Glycerol (5-10%), formamide (1-5%) or DMSO (2-10%) can be added in PCR for template DNA with high GC content (they change the Tm of primer-template hybridisation reaction and the thermostability of polymerase enzyme). Glycerol can protects Taq against heat damage, while formamide may lower enzyme resistence.
2. 0.5 -2M Betaine (stock solution - 5M) is also useful for PCR over high GC content and long stretches of DNA (Long PCR / LA PCR). Perform a titration to determine to optimum concentration (1.3 M recommended). Reduce melting temperature (92 -93 ¡ãC) and annealing temperature (1-2¡ãC lower). It may be useful to use betaine in combination with other reagents like 5%DMSO. Betaine is often the secret (and unnecessarily expensive) ingredient of many commercial kits.
3. >50mM TMAC (tetramethylammonium chloride), TEAC (tetraethylammonium chloride), and TMANO (trimethlamine N-oxide) can also be used.
4. BSA (up to 0.8 ¦Ìg/¦Ìl) can also improve efficiency of PCR reaction.
5. See also Dan Cruickshank's PCR additives and Alkami Enhancers for more.

i) PCR buffer

1. Higher concentration of PCR buffer may be used to improve efficiency.
2. This buffer may work better than the buffer supplied from commercial sources.
   
   16.6 mM ammonium sulfate
   67.7 mM TRIS-HCl, pH 8.89
   10 mM beta-mercaptoethanol
   170 micrograms/ml BSA
   1.5-3 mM MgCl2

j) The PCR product may be purified using a number of commercially available products or by gel-purificationif the template needed to be removed. It can also be sequenced.

k) Trouble shooting see Tavi's page, MycoSite, Alkami Biosystems,Promega and Sigma.

l) PCR methods

1. Hot-start PCR - to reduce non-specific amplification. Can also be done by separating the DNA mixtures from enzyme by a layer of wax which melts when heated in cycling reaction. A number of companies also produce hot start PCR products, See Alkami Biosystem.
2. "Touch-down" PCR - start at high annealing temperature, then decrease annealing temperature in steps to reduce non-specific PCR product. Can also be used to determine DNA sequence of known protein sequence.
3. Nested PCR - use to synthesize more reliable product - PCR using a outer set of primers and the product of this PCR is used for further PCR reaction using an inner set of primers.
4. Inverse PCR - for amplification of regions flanking a known sequence. DNA is digested, the desired fragment is circularise by ligation, then PCR using primer complementary to the known sequence extending outwards.
5. AP-PCR (arbitrary primed)/RAPD (random amplified polymorphic DNA) - methods for creating genomic fingerprints from species with little-known target sequences by amplifying using arbitrary oligonucleotides. It is normally done at low and then high stringency to determine the relatedness of species or for analysis of Restriction Fragment Length Polymorphisms (RFLP).
6. RT-PCR (reverse transcriptase) - using RNA-directed DNA polymerase to synthesize cDNAs which is then used for PCR and is extremely sensitive for detecting the expression of a specific sequence in a tissue or cells. It may also be use to quantify mRNA transcripts. See also Quantiative RT-PCR, Competitive Quantitative RT-PCR, RT in situ PCR, Nested RT-PCR.
7. RACE (rapid amplificaton of cDNA ends) - used where information about DNA/protein sequence is limited. Amplify 3' or 5' ends of cDNAs generating fragments of cDNA with only one specific primer each (+ one adaptor primer). Overlapping RACE products can then be combined to produce full cDNA. See also Gibco manual.
8. DD-PCR (differential display) - used to identify differentially expressed genes in different tissues. First step involves RT-PCR, then amplification using short, intentionally nonspecific primers. Get series of band in a high-resolution gel and compare to that from other tissues, any bands unique to single samples are considered to be differentially expressed.
9. Multiplex-PCR - 2 or more unique targets of DNA sequences in the same specimen are amplified simultaneously. One can be use as control to verify the integrity of PCR. Can be used for mutational analysis and identification of pathogens.
10. Q/C-PCR (Quantitative comparative) - uses an internal control DNA sequence (but of different size) which compete with the target DNA (competitive PCR) for the same set of primers. Used to determint the amount of target template in the reaction.
11. Recusive PCR - Used to synthesise genes. Oligos used are complementary to stretches of a gene (>80 bases), alternately to the sense and to the antisense strands with ends overlapping (~20 bases). Design of the oligo avoiding homologous sequence (>8) is crucial to the success of this method.
12. Asymmetric PCR
13. In Situ PCR
14. Mutagenesis by PCR
15. Far too many to list properly.

For more information, protocols and links, go to PCR jump station, Alkami Biosystem, Fermentas, Promega, and Sigma, See also PCR primer, PCR notes and PCR manual at Roche and Qiagen.

Other PCR links - PCR lectures, radio-labelled probes, Thermocycler suppliers

Standard PCR protocols
From Molecular Biology Techniques Manual, from the web site of the University of Cape Town, South Africa.
http://web.uct.ac.za/microbiology/pcr...   

T-DNA Generated Enhancer Traps in Arabidopsis
Application of inverse PCR, partial genomic libraries and TAIL-PCR in cloning flanking, at the Department of Biological Sciences, Dartmouth College, Hanover, NH.
http://www.dartmouth.edu/~tjack/   

Tavi's PCR protocols
A page describing the main parameters and trouble-shooting in PCR. The page is somewhat dated (updated 1997) but still useful.
http://info.med.yale.edu/genetics/war...   

Technical manual of PCR
Intended for specialists planning PCR procedures in their laboratories. From the University of Cape Town updated 2001.
http://web.uct.ac.za/microbiology/pcr...   

The Polymerase Chain Reaction
A popular description of the way it works, its importance in different connections, legal aspects. Authored by TM Powledge at the Federation of the American Societies of Experimental Biology.
http://www.faseb.org/opar/bloodsupply...   

The web guide of PCR
List of links and forum on the subject and related methodology. Set up and maintained by SJ Krivokapich, National University of Misiones, Argentina.
http://www.pcrlinks.com/   

Thermostable DNA Polymerases
Discussion of their origin and briefly their properties. From the web site of Colorado State University.
http://arbl.cvmbs.colostate.edu/hbook...   

Wayward PCR primers
Article by PN Hengen from TIBS 1995 on the loss of activity of PCR primers with time.
http://www-lecb.ncifcrf.gov/~pnh/pape...   

What the Heck is PCR?
Popular description of the PCR technique by John C Brown, University of Kansas 1995.
http://people.ku.edu/~jbrown/pcr.html   

Which DNA Marker for Which Purpose?
Compendia of the Research Project "Development, optimisation and validation of molecular tools for assessment of biodiversity in forest trees", European Union DGXII Biotechnology FW IV Research Programme. From the web site of the University Library, Gttingen.
http://webdoc.sub.gwdg.de/ebook/y/199...   

quot; Technique for Enhancing Detection of Small Deletions in Mutant Libraries
This method works because the poison allows the formation of deletion products but titers out full-sized products. From the Biotechnology Laboratory, University of British Columbia.
http://ko.cigenomics.bc.ca/poison1.html